what i mean is that in the tutorial it will be telling you to connect a servo to a pin on the botboard. My code might have these servos on different pins and so you might need to just remove the servo/s from the pins, making sure you reconnect them as the code indicates.
SO if in the tutorial it says connect the front right coxa servo to pin P1 then thats what you would have done.
But my code "Might" have the front right coxa servo on a different pin number so you need to check this.
the other option is to leave the connection as they are and correct them in the code. to do so 'once you have the code up in the IDE window you need to locate were these pins are assigned. and then all you need to do is delete the pin numbers and re-enter them as appointed in the tutorials.