Compiled SSC24 code

Post code examples here

Compiled SSC24 code

Postby paulp » Wed Mar 10, 2010 1:00 pm

Matt,

Ive noticed reference to the SSC24 code in places but havent seen a link to a pre-compiled version. Does such a thing exist?
paulp
 
Posts: 279
Joined: Wed May 21, 2008 8:30 pm
Location: Midlands U.K.

Re: Compiled SSC24 code

Postby Matt Denton » Fri Mar 19, 2010 9:23 am

H Paul,

I haven't uploaded a compiled version, but I'm sure I have the .hex file around somewhere..
Matt Denton
AKA: Winchy_Matt

micromagic systems ltd
Matt Denton
Site Admin
 
Posts: 1622
Joined: Tue May 20, 2008 9:15 pm
Location: Winchester UK

Re: Compiled SSC24 code

Postby paulp » Fri Mar 19, 2010 10:44 am

If you could, or email...

I'm going to attempt a 4dof quadraped based on Zenta's T-Hex in the Art Gallery..

To achieve this I could either run the LM-SSC32 or preferably the pBrain in SSC24 mode.

I'd like to have done a hexapod 4dof but seriously can't afford the extra servo's

Did you ever consider Quad gaits, coz I need a bit of direction on them
paulp
 
Posts: 279
Joined: Wed May 21, 2008 8:30 pm
Location: Midlands U.K.

Re: Compiled SSC24 code

Postby Matt Denton » Fri Mar 19, 2010 10:48 am

I will dig it out and email it over.

Your running an SMB+ds24 combo yes?

I presume you are intending to program the ds24 via the serial link? or are you going to wipe the HexEngine using and ICD2 or similar?

I did some work on quad gaits, but 10 years ago.. so not much help and no memory of it :)
Matt Denton
AKA: Winchy_Matt

micromagic systems ltd
Matt Denton
Site Admin
 
Posts: 1622
Joined: Tue May 20, 2008 9:15 pm
Location: Winchester UK

Re: Compiled SSC24 code

Postby paulp » Fri Mar 19, 2010 10:55 am

yes its the smb and ds 24...

I use the Microsockets PIC Programmer app over the Serial link so I can switch between the 2 as I want..
paulp
 
Posts: 279
Joined: Wed May 21, 2008 8:30 pm
Location: Midlands U.K.

Re: Compiled SSC24 code

Postby Matt Denton » Fri Mar 19, 2010 2:11 pm

Ok,

But then you will need an encrypted version of the SSC24 code.
Matt Denton
AKA: Winchy_Matt

micromagic systems ltd
Matt Denton
Site Admin
 
Posts: 1622
Joined: Tue May 20, 2008 9:15 pm
Location: Winchester UK

Re: Compiled SSC24 code

Postby paulp » Fri Mar 19, 2010 4:06 pm

Thanx Matt

Will play
paulp
 
Posts: 279
Joined: Wed May 21, 2008 8:30 pm
Location: Midlands U.K.


Return to Code Examples

Who is online

Users browsing this forum: No registered users and 2 guests

cron