HexEngine Config File

[wattsie]

Matt.... Im busy building a new hexapod, and before I go and rip my PBrain and SMB out of my MSRH01, I was wondering if there was a way to save the configuration and POD calibration files so I can restore them once I put the all the kit back into my MSRH01?? Having spent ages calibrating and configuring at the beginning, seem a shame to loose all the work.....

Or is the answer to write down each setting and re-enter them later on??

wattsie

[Matt Denton]

The best thing to do is to enter the CONFIG mode within terra term / hyper term and then capture the terminal output to a file, then use the LIST command, this will list all settings and calibration data. Now stop the file capture and you have your self a txt file with all the settings