Matt Denton wrote:.....Glad to see your up and running! Sorry about the dry solder joint, you should have let me know, I would have replaced the board
As for your PWM to serial interface, you would be best using the PIP interface, as it will allow you much higher degree of control. Also, you can send the signal into the Second TTL control port on p.Brain, this way you don't need to convert to bluetooth or rs232.
quadrocopter wrote:I was a bit inaccurate in my description
The idea was to create a small PPM two serial (TTL) module and plug it into the Bluetooth socket, but I see that it is OK to have a serial connection as well so I expect that it ends up connected to the RJ45 serial port.
Users browsing this forum: No registered users and 0 guests